Projects 2020 available on thingiverse

check out : https://www.thingiverse.com/thing:4128500





Kommentare

Kommentar veröffentlichen

Beliebte Posts aus diesem Blog

The Tools

The toolset used for this project is BLENDER ( https://www.blender.org/ ) and CURA ( https://ultimaker.com/en/products/ultimaker-cura-software ). BLENDER (God bless Ton Roosendaal) is used to design the 3d models and CURA to prepare the models for 3d printing. Related to BLENDER I found a very helpful articel about preparing blender files for 3d printing. Reading it is a must have https://daler.github.io/blender-for-3d-printing/contents.html https://www.shapeways.com/tutorials/prepping_blender_files_for_3d_printing https://www.sculpteo.com/en/tutorial/prepare-your-model-3d-printing-blender/ https://www.shapeways.com/tutorials/fixing-non-manifold-models https://www.shapeways.com/tutorials/creating-hollow-objects Here comes a list of collected and helpful keyboard shortcuts of blender. in edit mode: ALT+CRTL+SHIFT+m  :  is each mesh manifold (water tight) check f  :  fill / face creation an edge or face / combine two vertices / makes a line between 2 vertices CTRL+f  :
Mehr anzeigen

Project 2019 B

Bild
Another designing and printing experience of VANDEN. Used design software is BLENDER again. The exported *.stl files were prepared for printing using CURA. The physical printing has been performed using a cheap ANET E12 3d printer. This project has been done in the mid till the end of the third quarter in 2019. A puzzle for you: The rotor rotates around an embedded ball bearing in the middle onto a 8mm axle. The outer ring is a separated part and could be removed from the inner star like tracks. The ring includes 6x holes to connect the outer ring with the inner rotator. This needs to be done after putting the sliders into the tracks. A conus, to be maintained on a surface, holds the inner main axle where the ball bearing of the rotator lays on the small top. Some con-rods are required to combine the crank with the sliders: The crank has to be put on top of the inner axle to dis-center the con-rods. The con-rods rotating arond the small borehole whereas the bigge
Mehr anzeigen