Projects 2020 available on thingiverse

check out : https://www.thingiverse.com/thing:4128500





Kommentare

Kommentar veröffentlichen

Beliebte Posts aus diesem Blog

Project 2019 B

Bild
Another designing and printing experience of VANDEN. Used design software is BLENDER again. The exported *.stl files were prepared for printing using CURA. The physical printing has been performed using a cheap ANET E12 3d printer. This project has been done in the mid till the end of the third quarter in 2019. A puzzle for you: The rotor rotates around an embedded ball bearing in the middle onto a 8mm axle. The outer ring is a separated part and could be removed from the inner star like tracks. The ring includes 6x holes to connect the outer ring with the inner rotator. This needs to be done after putting the sliders into the tracks. A conus, to be maintained on a surface, holds the inner main axle where the ball bearing of the rotator lays on the small top. Some con-rods are required to combine the crank with the sliders: The crank has to be put on top of the inner axle to dis-center the con-rods. The con-rods rotating arond the small borehole whereas the bigge...
Mehr anzeigen

Project 2019_A - design, preparation and print

Bild
Let's start with a solid ring creation and let's call it part X. The ring is surrounded by 66 holes . The holes are in the same distance to each other. So it is even better to include the holes in the print job as drilling them manually afterwards. The ring is designed using BLENDER and  its inner diameter is 251 mm and the outer 266 mm. This dimension plus a buffer for the - so called - "brim" around the circle will nearly fill out the maximum print capabilites of the 3D print bed. The print bed - the plateau to print on - has a dimension of 300 mm x 300 mm. Steps to perform - written down one time in detail 1a) the solid ring open blender, remove default circle by pressing x press shift+c and center the cursor to 0,0,0 by selecting 'cursor to center' press num block 7 to view from top on the surface click add -> mesh -> circle add a ring - on the left panel choose 96 vertices, radius 133 (mm) press num block comma to center the current obje...
Mehr anzeigen